Loss on Drying (LOD) — What Is It?
Loss on Drying (LOD) is a parameter that quantifies the decrease in a sample’s mass during drying under specified conditions. The result is most often expressed as a percentage and includes volatile substances removed from the sample during the test.
LOD may include water, but also other volatile components if they are removed under the conditions used. For this reason, loss on drying should not automatically be equated with the exact water content.
The LOD parameter appears in specifications and quality control methods for various raw materials and products, including those in the food, pharmaceutical, and chemical sectors. When interpreting it, not only the result and the limit value are important, but also the test conditions, such as temperature, drying time, and, in some methods, pressure or the use of a drying agent.
Frequently Asked Questions
How is loss on drying determined?
The sample is weighed before drying and then subjected to the conditions specified in the relevant method. After drying and, if required by the procedure, cooling, the sample is weighed again. The loss in mass is relative to the initial mass of the sample and is usually expressed as a percentage.
The exact conditions for the determination depend on the product and the method used. Different drying temperatures and times are possible, and some procedures also involve drying under reduced pressure.
Does LOD refer to water content?
Not always. Loss on Drying measures the amount of volatile substances removed from the sample under specific test conditions. If, under the conditions used, the loss in mass results primarily from the removal of water, LOD can be used as an estimate of water content.
If the sample may also contain other volatile substances or if a more selective determination of water is required, an appropriate method for determining water content is used, such as Karl Fischer titration.
How should the LOD be interpreted in a specification or COA?
The LOD should be interpreted in conjunction with the limit value and the test method. If the drying temperature and time are specified alongside the maximum allowable value, they are part of the conditions under which this parameter must be determined.
When comparing results for two raw materials, verify that they were determined under the same or equivalent conditions. The percentage value alone, without information on the method, may not be sufficient for a proper comparison.
How does the LOD differ from the Karl Fischer method?
LOD is based on the change in sample mass during drying and may include various volatile substances removed under test conditions. The Karl Fischer method, on the other hand, is used to determine water content.
Therefore, the two results do not necessarily have to be the same. The choice of the appropriate method depends on the nature of the product, the purpose of the test, and the requirements specified in the specification, standard, or relevant analytical procedure.